Non Metallic Floor Hardener

NON METALLIC FLOOR HARDENER

MASTERPAV Non-Metallic Floor Hardener NM200 is a blend of silica quartz, Portland Cement, plasticizers and dispersants. It is a dry-shake hardener applied over freshly placed concrete by power float finish to provide for a hard durable floor surface for both commercial and industrial use such as factory floors, commercial floors, car parks for hotels and condominiums, etc.

It is available in natural colour or coloured choices.

Benefits

Durable
Cost effective
Improve surface finishing
Improve floor aesthetics
Wide range of colours

System Information

Packaging: 25 kg per bag (NM200)
10 litre & 20 litre per pail (CM80)
Consumption: 5 - 6 kg per sq mtr (NM200)
7 - 10 sq mtr per litre (CM80)

Instruction for Use

SURFACE PREPARATION

Prepare and lay the fresh concrete as per requirements. Note that the concrete must be a minimum of G25 or compressive strength of 25 N/mm².

After the concrete has been screeded, consolidated and the surface is floated by power trowel. Ensure that any free water present has evaporated or removed in order to proceed to application.


APPLICATION - NM200

Dry shake the NM200 Colour Hardener evenly over the surface. The first application of the color hardener should use about 2/3 of the total amount needed. The dry shake materials will absorb some moisture from the freshly prepared concrete and should then be thoroughly power floated into the surface. Immediately after this the remainder of the specified amount of the NM200 Color Hardener should be distributed evenly over the surface at right angles to be previous application. This should be thoroughly power floated and make sure that an uniform colors is obtained. 


CURING - CM80

As soon as the surface has hardened the floor should be covered with MASTERPAV Curing Compound CM80.

Share by: