SURFACE PREPARATION:

Prepare and lay the fresh concrete as per requirements. Note that the concrete must be a minimum of G25 or compressive strength of 25 N/mm².

After the concrete has been screeded, consolidated and further level by bull float. Ensure that any free water present has evaporated or removed in order to proceed to application.

APPLICATION - BF100

Dry shake the MASTERPAV BF100 evenly over the surface. The first application of the BF100 should use about 2/3 of the total amount needed. The dry shake materials will absorb some moisture from the freshly prepared concrete and should then be thoroughly floated into the surface, preferably by a bull float. Immediately after this the remainder of the specified amount of the BF100 should be distributed evenly over the surface at right angles to be previous application. This should be thoroughly floated and make sure that an uniform colors is obtained. Final trowelling is best done by hand. 

BROOM FINISHING

After 30 minutes (Periodical checking of the condition and development of the concrete will determine the correct time frame for each stage and sequence of application), broom the concrete. Align long wooden plank as a reference for a straight broom finishing.

SEALING

After the floor is dried, apply MASTERPAV Acrylic Sealer for a high gloss, gloss, semi-gloss or matte finishing. Application of MASTERPAV Primer Sealer AS20 is highly recommended before the application of 2nd coat Acrylic Sealer.