EC10 Solvent Free Epoxy sealer

MASTERPAV EC10 Solvent Free Epoxy sealer

MASTERPAV EC10 is a two-component, low-viscosity epoxy sealer primer. When applied over concrete surfaces MASTERPAV EC10 penetrates and enhances the surface to provide increased wear resistance for indoor use.

  • BENEFITS


    Good penetration into the concrete surface

    Good resistance against mild chemicals


    Compatible with a wide range of topcoats

    No strong odor during application

    Low VOC content


  • PRODUCT INFORMATION

    PACKAGING

    Available in:

    ·        4.5kg set (3.6kg Part A : 0.9kg Part B)

    ·        1.0kg set (0.8kg Part A : 0.2kg Part B)



    THEORETICAL COVERAGE

    Sealer

    1st coat           : 0.2 kg/m2

    2nd coat           : 0.1 kg/m2 


    Primer

    1st coat           : 0.3 kg/m2


    *Depends on substrate porosity and texture, and application method. Excessive build-up should be avoided.


  • INSTRUCTION TO USE


    SURFACE PREPARATION

    a)The concrete surface to receive the MASTERPAV EC 10 Solvent Free Epoxy Sealer shall be free of all contaminants that could affect the adhesion. Grinding and sanding the concrete surface before application is highly recommended.


    b)It is recommended to conduct concrete moisture test before application of MASTERPAV EC 10 Solvent Free Epoxy Sealer. Concrete substrate shall have moisture content of maximum 4%. For concrete substrate with moisture content higher than 4%, a moisture barrier is recommended.


    c)All cracks are to be rectify before actual application.


    EC10 APPLICATION

    a)Open Part A and Part B and thoroughly stir each part separately to eliminate settling. Mix   the content of Part B into Part A and stir until homogenous. 


    b)Applied by roller or brush. Ensure that a sufficient material is applied evenly over the entire surface to ensure maximum penetration.


    c)Apply 1st coat of EC10 according to recommended coverage. Let the surface dry for 12 hours.


    d)If EC10 is to be applied on smooth concrete surface (eg: table top), before applying the 2nd coat, light sanding the unevenness of the 1st coat until smooth, follows by wiping off dust using appropriate solvent (eg: MASTERPAV Thinner 101).  


    *(The unevenness of the 1st coat usually caused by the porous nature of the substrate. The degassing of the entrapped air in the substrate pores will cause the formation of bubbles on the coating surface).

                                                                                          

    e)The already cleaned & smooth 1st coat is now ready to receive 2nd coat of EC10.


    f)For application in enclosed areas, provide sufficient ventilation to ensure proper drying of the applied materials.


    g)MASTERPAV EC 10 must be applied within its pot life time (2 hours).


Share by: