MASTERPAV Slip Resistant Acrylic Sealer AS3.0 is a solvent-based clear finish that dries fast and imparts low gloss, extra hard and durable, good water resistant, UV stability, and good protection to concrete surfaces. It is also pre-blend with special additives for slip-resistant properties.
Slip Resistant Acrylic Sealer AS3.0 is suitable for residential and commercial areas. It can be coated on interior and exterior concrete imprint surfaces, floor pebble finish; slate, and other concrete flooring materials.
Gloss level: Low gloss
Slip Resistant properties
Hard, durable, and trafficable
Good resistance to fungal, and alkali attacks, dust collection
Resistant to weathering on exposure
Good water-resistant, washable finish
Enhance the color of the substrates
Protection level: High
Packaging : 5 liter, 20 liter
Consumption : 4 -5 sq mtr per liter
Note: The rate of consumption depends on the substrate porosity and texture.
SURFACE PREPARATION
Ensure the substrate is clean and dry. Remove any grease by detergent or alkaline etch. Loosely bound particles can be removed by air blower. Any algae, mildew or moss should be removed.
MIXING
Stir well before using.
APPLICATION
Apply using roller or brush. Allow sealer to dry for 24hours for light traffic and at least 72 hours for heavy vehicle. For maximum protection, two coats of Anti-Slip Sealer AS 3.0 can be applied wait approximately 1 – 2 hours between coats.
PLEASE NOTE
Anti-Slip Sealer AS 3.0 is not recommended for substrates that contain high moisture. Spot test can be conducted to determine the surface which can receive Anti-Slip Sealer AS 3.0.